Bedienungsanleitung ION iProfile Plattenspieler

Bedienungsanleitung

5

TROUBLESHOOTING

Refer to the following troubleshooting scenarios if you experience difficulty recording your vinyl to your iPod or computer.

PROBLEM CAUSE SOLUTION

Needle is not on the record. Place the needle on the record.

Turntable not powered.

Make sure that the turntable is connected to a live power outlet

and that it is powered on.

I am not hearing any audio

when I am recording.

RCA outputs not connected to

speaker system.

Make sure you have connected the turntable’s RCA outputs to a

speaker system and that the speaker system is powered on.

Cartridge connection is not

secure.

Cartridge must be securely connected to the tonearm whenever

you are using the turntable.

Vinyl record is dirty or

scratched.

Try dusting off and gently wiping the surface of the record before

playing it.

I am experiencing poor

sound quality.

iPod is charging while recording.

To ensure maximum audio quality, iPod charging should be

turned off while recording. If you have turned this feature on,

please disable it by pressing |<< and >>| simultaneously.

When recording vinyl to my

computer, the recording

sounds loud and distorted.

The turntable volume is too

high.

Turn down the volume knob.

When recording vinyl to my

computer, the recording is

barely audible.

The turntable volume is too low. Turn up the volume knob.

I cannot hear my recordings

when I try to play them from

my computer.

While the turntable is

connected, I cannot listen to

any music from my

computer.

Computer audio output not set

correctly.

Make sure that your computer’s audio playback options are

configured in one of the following ways:

 In Windows XP, go to Start  Control Panel  Sounds

and Audio Devices (on Windows XP) or Start  Control

Panel  Sound (on Windows Vista) and make sure that

your computer’s audio card is selected as the Sound

Playback device under the Audio tab.

 Alternatively, you can play audio from your computer

through the turntable’s RCA audio outputs. Simply select

“USB Audio Codec” as the Sound Playback device and any

audio from your computer will play through the turntable’s

RCA outputs.

When recording into my

computer on Windows Vista,

my recordings are mono

instead of stereo.

Recording input properties in

Vista not set to “stereo”.

In Vista, you may need to manually specify “stereo” for the

recording input.

Go to Start  Control Panel  Sound (in Classic View). Then,

click on the Recording tab and highlight the Microphone input

(USB Audio Codec). Click on Properties to bring up the input

settings. Next, click on the Advanced tab and select “2 channel,

16 bit, 44100 Hz (CD quality)” in the Default Format pull-down

menu. Lastly, click Apply to accept the settings.

iPod not docked properly.

Make sure that the iPod is properly connected to the dock. We

recommend using the Universal Dock Adapter, included with your

iPod.

iPod is synced to your

computer.

You will not be able to record to your iPod while it is synced to

your computer through the USB connection. Eject the iPod from

your computer, then hold the turntable's Sync button for two

seconds to connect it again.

I am not able to record to my

iPod.

iPod is not in Record Mode

(Voice Memo).

Ensure that your iPod is in Record Mode. Navigate to Extras 

Voice Memos in your iPod. Then, press Select on the turntable

to begin recording.

The platter is not rotating. The belt drive has come loose.

Place the tonearm back in its resting position to stop the turntable

motor. Then, rotate the platter until you can see the motor

spindle in one of the holes. Reach into the hole and pull the

rubber drive belt off of the inner ring and install it over the motor

spindle. Be careful not to twist the rubber drive belt during this

step. Check to make sure the platter rotates uniformly. If the

drive belt is properly installed, there should be a slight amount of

tension that brings the platter to a stop after spinning it freely.

My music is playing at a

strange pitch.

Incorrect speed selected on the

turntable.

Make sure that you are playing your records at the speed they

were intended to be played. Select between the two different

speeds by pressing 33RPM or 45RPM.

BEFORE RETURNING THE PRODUCT, please contact ION Audio or your retailer for technical support.

Contact information can be found in the Safety Instruction Booklet included with this product.

Bewertung

Mehr zu diesem Bedienungsanleitung

Wir verstehen, dass es schön ist, ein gedrucktes Bedienungsanleitung für Ihr ION iProfile Plattenspieler zu haben. Sie können das Bedienungsanleitung jederzeit von unserer Website herunterladen und selbst ausdrucken. Wenn Sie ein Originalhandbuch wünschen, empfehlen wir Ihnen, ION zu kontaktieren. Möglicherweise können sie ein Originalhandbuch bereitstellen. Suchen Sie das Bedienungsanleitung Ihres ION iProfile Plattenspieler in einer anderen Sprache? Wählen Sie auf unserer Homepage Ihre bevorzugte Sprache und suchen Sie nach der Modellnummer, um zu sehen, ob wir sie verfügbar haben.

Spezifikationen

Alle Anleitungen für ION Plattenspieler
Weitere Anleitungen von Plattenspieler

Häufig gestellte Fragen zu ION iProfile Plattenspieler

Unser Support-Team sucht nach nützlichen Produktinformationen und beantwortet Ihre häufig gestellten Fragen. Sollte Ihnen ein Fehler bei den häufig gestellten Fragen auffallen, teilen Sie uns dies bitte anhand unseres Kontaktformulars mit.

Verwandte Produkte

Bedienungsanleitung

ION Mobile LP Plattenspieler

Bedienungsanleitung

ION LP 2 Flash Plattenspieler

Bedienungsanleitung

ION LP 2 Go Plattenspieler

Bedienungsanleitung

ION Max LP Plattenspieler

Bedienungsanleitung

ION Archive LP Plattenspieler

Bedienungsanleitung

ION Profile Flash Plattenspieler

Bedienungsanleitung

ION Vertical Vinyl Plattenspieler

Bedienungsanleitung

ION Quick Play LP Plattenspieler

Verwandte Kategorien