Bedienungsanleitung Black and Decker KC8402 Bohrschrauber

Bedienungsanleitung

3

However, if the outer seal is broken and this

leakage gets on your skin:

•Wash quickly with soap and water.

•Neutralise with a mild acid such as lemon

juice or vinegar.

•If battery liquid gets into your eyes, flush

them with clean water for a minimum of

10 minutes and seek immediate medical

attention. (Medical note: The liquid is a

25-35% solution of potassium hydroxide.)

•Do not attempt to open your drill/driver or

charger housings’ or the battery pack.

•Do not attempt to recharge non-rechargeable

batteries.

•The supply cord of the charger should not be

replaced by the customer; if the cord is

damaged it should be replaced at an authorised

Black & Decker service centre.

•Ensure that the battery pack is correct for the tool.

•Ensure that the outside surface of the battery

pack or tool is clean and dry before plugging into

the charger.

•Ensure that the battery is charged using the

correct charger recommended by the

manufacturer. Incorrect use may result in a

risk of electric shock, overheating or leakage of

corrosive liquid from the battery.

Save these instructions!

Electrical safety (UK only)

•Your equipment is fitted with two core cable and

a non rewirable plug. The plug is fitted with a

3 amp fuse which should only be replaced with

an identical fuse approved to BS1362.

Note: Fuses do not give personal protection against

electric shock.

•After changing the fuse in your plug always

ensure the fuse cover is refitted. If the fuse cover

is missing or damaged do not use the plug.

For replacement or detachable fuse covers

contact a Black & Decker service centre.

•Tools supplied with loose Black & Decker

extension cable and have a 13 amp plug fitted

are supplied with a 13 amp fuse, which is the

recommended fuse for the extension cable.

Note: If a non Black & Decker extension cable is to

be used on this product the recommended fuse

stated in the literature should be fitted to the plug.

ENGLISH

Charger plug and cable

•Do not tug at the cable to pull the plug from

the socket.

•Make sure the cable is located so that it will not

be stepped on, tripped over, or otherwise

subjected to damage or stress.

•Keep the cable away from heat, oil, sharp edges

and rough surfaces and always ensure it is in

good condition.

Additional drill and charger

safety rules

•Danger! 240 volts are present at the charging

terminals. Do not probe with conductive objects

or you will risk an electric shock.

•Danger! If the energy pack case is cracked or

damaged, do not insert into the charger or you

will risk an electric shock.

•The charger is designed for indoor use only.

•Do not operate the charger if it has received

a sharp blow, been dropped, or otherwise

damaged in any way. Take it to a Black & Decker

service centre.

•Never attempt to connect two chargers together.

•Always disconnect the supply before making

or breaking connections to the battery.

•Be aware that this tool is always in an operating

condition, because it does not have to be

plugged into an electrical outlet. Keep the switch

control lever in the “Off” position when the tool is

not in use or when changing accessories.

•When drilling or driving screws into walls, floors

etc., check wherever “live” electrical wires may

be encountered. Do not touch any front metal

parts of the tool! Hold the tool only by the

plastic housing.

•The charger and drill/driver are specifically

designed to work together. Do not attempt to

charge the drill/driver with any other charger

than the one supplied with the tool.

•Do not store the tool in locations where the

temperature may reach or exceed 50˚C (120˚F)

(such as outside sheds or metal buildings

in summer).

•Do not charge your drill/driver when it or the air

temperature is below (+40˚F) 4˚C or above

(+105˚F) 40˚C. This is important and may prevent

serious damage to the battery.

•Do not incinerate the drill/driver even if it is

severely damaged or completely worn out.

The battery pack can explode in a fire. A small

leakage of liquid from the battery cells may occur

under extreme usage, charging or temperature

conditions. This does not indicate a failure.

Bewertung

Mehr zu diesem Bedienungsanleitung

Wir verstehen, dass es schön ist, ein gedrucktes Bedienungsanleitung für Ihr Black and Decker KC8402 Bohrschrauber zu haben. Sie können das Bedienungsanleitung jederzeit von unserer Website herunterladen und selbst ausdrucken. Wenn Sie ein Originalhandbuch wünschen, empfehlen wir Ihnen, Black and Decker zu kontaktieren. Möglicherweise können sie ein Originalhandbuch bereitstellen. Suchen Sie das Bedienungsanleitung Ihres Black and Decker KC8402 Bohrschrauber in einer anderen Sprache? Wählen Sie auf unserer Homepage Ihre bevorzugte Sprache und suchen Sie nach der Modellnummer, um zu sehen, ob wir sie verfügbar haben.

Spezifikationen

Alle Anleitungen für Black and Decker Bohrschrauber
Weitere Anleitungen von Bohrschrauber

Häufig gestellte Fragen zu Black and Decker KC8402 Bohrschrauber

Unser Support-Team sucht nach nützlichen Produktinformationen und beantwortet Ihre häufig gestellten Fragen. Sollte Ihnen ein Fehler bei den häufig gestellten Fragen auffallen, teilen Sie uns dies bitte anhand unseres Kontaktformulars mit.

Verwandte Produkte

Bedienungsanleitung

Black and Decker KC1451CN Bohrschrauber

Bedienungsanleitung

Black and Decker HP128F2K Bohrschrauber

Bedienungsanleitung

Black and Decker KC1261F Bohrschrauber

Bedienungsanleitung

Black and Decker BCD003 Bohrschrauber

Bedienungsanleitung

Black and Decker BD12S1 Bohrschrauber

Bedienungsanleitung

Black and Decker KC12CE Bohrschrauber

Bedienungsanleitung

Black and Decker KC7251 Bohrschrauber

Bedienungsanleitung

Black and Decker ASL186 Bohrschrauber

Verwandte Kategorien