Bedienungsanleitung AEG RTE 5050 SN Thermostat

Bedienungsanleitung

1. Applications

This electronic temperature controller is designed for

controlling the room temperature in conjunction with:

• heating systems e.g. hot-water heaters, convector hea-

ters or floor heating

• electric convector heaters, ceiling and storage heating

• night storage heaters

• circulation pumps

Features

• Nighttime set-back, input for external clock

• Indicator lamps for "controller calls for heat" and for

set-back operation

• 2-poel mains switch

• Mounting in 55 mm appliance socket

2. Description of functions

2.1 Functions

The room temperature is measured by the integrated

sensor and is set via the outer dial.

The scale of *…6 corresponds to 5…30°C.

Lamps

Red: Controller calls for heat

Green: Set-back mode is activated

2.2 Functions of the set-back input TA

èè

The TA input is used to set the thermostat into the ener-

gy saving mode (by using an external timer).

In this mode, the room temperature will be reduced by

3° or 5° (depending on jumper J2).

2.3 Selecting the set-back temperature

By means of the J2 jumper it is possible to select 3° or

5°.

J2 closed* set-back by 5°C

J2 open set-back by 3°C

* = factory pre-set

The temperature set externally via the dial is reduced by

this value.

2.4 Remote sensor

For measuring the room temperature a remote sensor

can be used instead of the internal one.

If the remote sensor is connected, the internal one auto-

matically will be disabled.

Note: In order to change from remote sensor to inter-

nal sensor, master reset has to be activated (see 2.6).

The remote sensor is not part of delivery.

Caution-1!

The device may only be opened and installed ac-

cording to the circuit diagram on the device or these

instructions by a qualified electrician. The existing

safety regulations must be observed.

In order to comply with safety class II, the necessary

installation steps must be taken.

This independently mountable electronic device is

designed for controlling the temperature in dry and

enclosed rooms only under normal conditions.

The device confirms to EN 60730, it works according

operating principle 1C

2.5 Function of the lamps

Function Lamp green Lamp red

Heating is on on

Set-back mode on

external sensor failure blink blink

2.6 Master Reset

In case of unexpected behaviour of the controller

Master Reset should be carried out by performing the

following steps:

Note the state of Jumper 2

Switch off power supply

Change state of J2

Switch on power

Switch off power

Set the original state of J2

Switch on power.

Now the internal sensor is active.

3. Mounting / Commissioning

The controller should be mounted at a point in the

room which:

• can be easily accessed

• is free of curtains, cabinets, shelves, etc.

• allows free air circulation

• is not exposed to direct sunlight

• is not draughty (when doors or windows are opened)

• is not directly influenced by the source of heat/cold

• is not located on an outer wall

• is approx. 1.5 m above the floor.

Electrical connection

Perform the steps described below:

• Pull off the temperature dial

• Release the fixing screw

• Remove the upper part of the casing

• Connect acc. to circuit diagram (see bottom of casing)

Remote sensor

Do not install the sensor close to mains cables. In other

cases a shilded cable has to be used.

The sensor can be extended to max. 50 m by means of

a cable suitable for mains voltage.

Caution! Sensor leads carry mains voltage (230 V).

4. Technical data

Order designation RTE 5050 SN

Temperature setting range:*…6 (5…30ºC)

Indicator lamp red Controller calls for heat

green Set-back temperature

Power switch 2-pole

Supply voltage 230V AC (195…253V)

50Hz

Output Relay make contact

Switching current: 100mA…16A cosϕ = 1;

100mA… 2A cosϕ = 0.6

Control algorithm Proportional controller

(similar to continuous

through PWM)

Switching temperature

differential ~0,5°C

Temperature sensor: internal

Temperature set-back 3K or 5K selectable

via external timer

Range limitation inside the dial

Degree of protection

of casing IP30

Safety class II (see Caution-1)

Software class A

Degree of polution 2

Calculation impulse voltage 2,5 kV

Temperature for the

Ball compression test 75°C

Voltage and Current for

the for purposes of

interfernce measurements 230V, 16A

Ambient temperature 0…40ºC

Storage temperature –25…70ºC

Weight 90 g

Caution! De-energize the electric circuit first

Sensor characteristics

10°C 66.8 kΩ 30°C 26.3 kΩ

20°C 41.3 kΩ 40°C 17.0 kΩ

25°C 33 kΩ 50°C 11.3 kΩ

5. Circuit diagram

Caution: 

Through-connector for earth (PE conductor)

Position of the jumpers

6. Dimensions

468 931 003 294-1



Instructions for use

and assembly

Electronic room temperature controller

with set-back input

RTE 5050 SN

Errors possible-subject to alterations 280927/34615/2/0743

Bewertung

Mehr zu diesem Bedienungsanleitung

Wir verstehen, dass es schön ist, ein gedrucktes Bedienungsanleitung für Ihr AEG RTE 5050 SN Thermostat zu haben. Sie können das Bedienungsanleitung jederzeit von unserer Website herunterladen und selbst ausdrucken. Wenn Sie ein Originalhandbuch wünschen, empfehlen wir Ihnen, AEG zu kontaktieren. Möglicherweise können sie ein Originalhandbuch bereitstellen. Suchen Sie das Bedienungsanleitung Ihres AEG RTE 5050 SN Thermostat in einer anderen Sprache? Wählen Sie auf unserer Homepage Ihre bevorzugte Sprache und suchen Sie nach der Modellnummer, um zu sehen, ob wir sie verfügbar haben.

Spezifikationen

Alle Anleitungen für AEG Thermostate
Weitere Anleitungen von Thermostate

Häufig gestellte Fragen zu AEG RTE 5050 SN Thermostat

Unser Support-Team sucht nach nützlichen Produktinformationen und beantwortet Ihre häufig gestellten Fragen. Sollte Ihnen ein Fehler bei den häufig gestellten Fragen auffallen, teilen Sie uns dies bitte anhand unseres Kontaktformulars mit.

Verwandte Produkte

Bedienungsanleitung

AEG RTi 103 EP Thermostat

Bedienungsanleitung

AEG FTE 600 SN Thermostat

Bedienungsanleitung

AEG FRTD 903 Thermostat

Bedienungsanleitung

AEG RT 600 Thermostat

Bedienungsanleitung

AEG FTE 5050 SN Thermostat

Bedienungsanleitung

AEG RTi 600 M HF Thermostat

Bedienungsanleitung

AEG RT 5050 SZ Thermostat

Bedienungsanleitung

AEG RT 602 SN SZ Thermostat

Verwandte Kategorien